Fiat 500 Key Fob Replacement
If your 500 key fob isn't working Try another one to see if your car will recognize it. If it does, the issue is likely with the original fob's battery, or water damage.
First replace the battery. The "+" side should be facing down.
Dead Battery
The battery is usually the reason for a fob not working. This isn't a problem to solve and most fobs provide you with a warning if the battery is dying. There are instructions for most car fobs on YouTube or in your owner's guide. You can also take it to an area locksmith or the dealer that gave it to you to replace it.
Sometimes a fob will stop working due to a glitch on the circuit board inside. It's not often but it does occur. If you drop the fob on something sharp, it could damage the internal chip. This is also the case if you use an aftermarket key, and the fob doesn't function. In this instance it is imperative to visit a dealer locksmith to have the key reset to make it compatible with your 500.
One 2012 FIAT FIAT 500 flip key remote that resembles Ilco with locks, unlocks, and trunk buttons – new keyless entry replacement (will need to cut & program by a locksmith).
Chips that are damaged
A key fob with the fiat 500 number is an electronic device that transmits an indication for the car to start when you push the button. fiat key programming is equipped with a microchip that contains information about the code needed to communicate with your car. If the chip is damaged, it won't transmit the correct code, and the car won't begin. It is possible to repair this type of damage, and a locksmith can help. United Locksmith is capable of offering this service to classic models as well as the latest ones, so don't hesitate to call them. scared to contact them.
A locksmith can program an entirely new key fob. This is less expensive than visiting a dealer and will work exactly the same way. You'll have to provide some information for the locksmith, like the year that your car was built and the model.
If you're not sure how to solve this issue, try scratching the chip with the help of a US dollar bill. The copper on the bill is abrasive enough remove oxidation and dirt, but it will not cause any harm to the microchip. If the chip is physically damaged it might not be repairable. This could happen if you drop the chip or run it over by your vehicle.
Water Damage
Water damage is likely to occur on your fob, no matter if you dropped it in the pool by accident or left them in pockets while swimming, or splashed water over them during a rainy afternoon. Even if there's only a small amount of water on its key, it can cause serious problems to its electronics and prevent it from working efficiently.
The good news is that you can often solve this issue by taking off the fob's key and using a a paper towel to clean it of any remaining dirt or water. Once the fob has dried and is dry, you can replace its battery. It should then start functioning normally.
You can take it to an auto repair shop or locksmith to get it professionally programmed and cleaned. These professionals can use special equipment to make sure that the key fob works with your car's computers.
If the key fob of your Fiat 500 stops working, you might feel angry and overwhelmed. It can be expensive and difficult to transport your key fob to a dealer. Locksmiths can handle every aspect of the replacement of your car's key fob without the need for a dealership visit. They are a much better option than a dealership.
Pairing Issues
If you drop your key fob or it stops working but nothing else seems to be wrong with it It could be due to the chip that has gone awry. This could be due water damage or the battery is dead.
This can be accomplished by following the directions in the owner's manual. If you're having problems or your manual doesn't work and you need to have an automotive locksmith perform this task. This will ensure that the chip is not damaged, and is the cheapest option.
500 owners have reported that their key fobs will not lock their cars. This can be a problem when you intend to fill up at the gas station. Some owners have even reported the locking mechanism on their 500's failing and having to replace the entire intermediate shaft for steering. This issue was described in a technical support bulletin (TSB) issued by Fiat.
A reputable locksmith is able to assist you when your Fiat has issues. They'll be able to duplicate your key, or make you a new one that will lock and start the car. They can make this happen without ever seeing your old key and are usually less expensive than buying it from the dealership.